1.) remove all screws from around door, 7 off
2.)remove door handle (see photo) mirror control and top speaker. (and associated wiring) yes that is ice on the windows I must be bloody mad!!


3.) remove 3 screws from door handle and 1 from lever (door handle middle screw is longest one)
5.)lift door panel out at bottom about 2 inches then up, its tight/very tight
fit alientech as per instructions using wiring details below.
alientech car solid/trace
green black/yellow
black yellow/black
blue brown
yellow white/yellow
white brown/yellow
orange grey/red
red grey/black
reassembly is reverse of removal but I advise you connect up the door control/locking without putting on the door trim and test everything first (before you re-assemble everything). Your finished look as to the wiring will look a lot better than mine as I had to figure out what wire went where! it works with the Skoda without an alarm due to the safe locking system, if you disable that (led on drivers door does not flash) alientech wont work. it worked for me it should work for you. and here's another photo for you.
